Ricoh Pro C5200s Operating Instructions Troubleshooting: Tcru/Oru

1. In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu,
select [Number of Sheet Align for Stapling], and reduce the number of sheets to be
stapled.
2. Print the image. Has the problem been resolved?
Yes Finished!
No If the problem persists even though the setting has reached its minimum value, contact your
service representative.
• If the number of sheets to be stapled is reduced, paper alignment will take longer, compromising
the machine's throughput.
Paper Edges Are Stained (1) (Finisher SR5070 / Booklet Finisher SR5080)
Cause:
While upward curls are removed, toner adhesion becomes insufficient when the fusing pressure roller is
applied to the paper, making the anti-static brush stained with toner.
This may occur if:
• Downward curled paper is used.
• Sheets are delivered with their printed side facing up in the post-processing machine.
Solution:
Print with the printed side face up for single-sided printing.
Paper Edges Are Stained (2) (Finisher SR5070 / Booklet Finisher SR5080)
5 mm
(0.2 in.)
DSN011
Finisher
93

Ricoh Pro C5200s Specifications

General

Print Technology	Laser
Max Paper Size	330.2 x 487.7 mm
Monthly Duty Cycle	300, 000 pages
Print Speed	65 ppm
Resolution	1200 x 4800 dpi
Paper Input Capacity	8, 250 sheets
Paper Weight	52 to 360 gsm
Duplex Printing	Standard
Network Connectivity	Ethernet 10Base-T/100Base-TX/1000Base-T
Supported Media Sizes	A3, A4, A5, B4, B5
Supported Media Types	Plain, Recycled, Coated, Envelope
Warm-up Time	Less than 5 minutes