3. Make a note of the present value in the following setting in [Advanced Settings] for the
custom paper in use.
<Printing in black and white>
[Paper Transfer Current: LE: BW]
<Printing in full color>
[Paper Transfer Current: LE: FC]
4. Increase the scaling factor in the above setting by 5 percentage points.
5. Print the image. Is the problem resolved?
Yes Finished!
No Increase the scaling factor by 5 percentage points.
6. Repeat Step 5. If the problem persists even though you have increased the scaling factor
by 50 percentage points, restore the value noted in Step 3 and go to the next step.
7. Decrease the scaling factor in the above setting by 5 percentage points.
8. Print the image. Is the problem resolved?
Yes Finished!
No Decrease the scaling factor by 5 percentage points.
9. Repeat Step 8. If the problem persists even though you have decreased the scaling factor
by 50 percentage points, restore the value noted in Step 3 and contact your service
representative.
Periodic Density Fluctuation
The vertical density fluctuates periodically.
Density Problems
49
To Next Page
Loading...
