• For one-sided printing (delivery of inverted paper), reduce the value in [Exit Switchback
Motor Speed: CCW] by 0.1%.
2. Print the image. Is the problem resolved?
Yes Finished!
No Keep decreasing the value by 0.1% until the problem is resolved.
If the problem persists even though you have decreased the value by 1.0%, contact
your service representative.
<If scratches or streaks appear on the side 1 of the paper>
You can lessen the problem by increasing the paper feed speed.
1. In [Advanced Settings] for the custom paper in use, adjust the paper feed speed for delivery.
Depending on the type of printing, specify one of the following:
• For one-sided printing, increase the value in [Paper Output Motor Speed] by 0.1%.
• For duplex printing, increase the value in [Switchback Entrance Motor Speed] by 0.1%.
• For one-sided printing (delivery of inverted paper), decrease the value in [Exit
Switchback Motor Speed: CCW] by 0.1%.
2. Print the image. Is the problem resolved?
Yes Finished!
No Keep increasing the value by 0.1% until the problem is resolved.
If the problem persists even though you have increased the value by 1.0%, contact
your service representative.
The Leading/Trailing Edge Margin Is Long
Cause:
In some custom paper presets, the leading/trailing edge margins are wide enough to prevent paper
jams.
Paper Feed Problems Affecting Image Quality
81
To Next Page
Loading...
