Rigol MSO2000A Series

2 Command System RIGOL
MSO2000A/DS2000A Programming Guide 2-1
2 Command System
This chapter introduces the command subsystems of MSO2000A/DS2000A command set.
The topics of this chapter:
 :AUToscale
 :CLEar
 :RUN
 :STOP
 :SINGle
 :TFORce
 :TLHAlf
 IEEE 488.2 Common Commands
 :ACQuire Commands
 :BUS<n> Commands
 :CALCulate Commands
 :CALibrate Commands
 :CHANnel<n> Commands
 :CURSor Commands
 :DISPlay Commands
 :FUNCtion Commands
 :LA Commands (MSO2000A/MSO2000A-S)
 :LAN Commands
 :MASK Commands
 :MEASure Commands
 :OUTPut<n> Commands (MSO2000A-S/DS2000A-S)
 :RECall Commands
 :REFerence Commands
 :SAVE Commands
 :SOURce<n> Commands (MSO2000A-S/DS2000A-S)
 :SYSTem Commands
 :TIMebase Commands
 :TRACe<n> Commands (MSO2000A-S/DS2000A-S)
 :TRIGger Commands
 :WAVeform Commands
Note:
1. Unless otherwise noted, in this manual the introductions and parameter ranges are based on
MSO2302A-S.
2. For parameter setting commands (for example, the time, frequency and amplitude), the oscilloscope
can only accept numbers and set the parameters using the default units; it cannot recognize the
units sent with the parameters. For the default unit of each parameter, please refer to the description
in each command in the following introductions.