Rigol MSO2000A Series Programming Guide

3 Programming Demos RIGOL
MSO2000A/DS2000A Programming Guide 3-1
3 Programming Demos
This chapter lists the programming demos to illustrate how to program and control the oscilloscope in the
development environments of Excel, LabVIEW, Matlab, Visual Basic 6.0 and Visual C++ 6.0 using SCPI
commands on the basis of NI-VISA.
NI-VISA (National Instrument-Virtual Instrument Software Architecture) is an advanced application
programming interface developed by NI (National Instrument) and is used for communication with
various instrument buses. It communicates with instruments in the same method regardless of the type of
the instrument interface (GPIB, USB, LAN/Ethernet or RS232).
NI-VISA calls the instruments that communicate with it via various interfaces as “resources”. The VISA
descriptor (namely the resource name) is used to describe the accurate name and location of the VISA
resource. For example, when the LAN interface is used to communicate with the instrument, the VISA
descriptor is TCPIP::172.16.3.4::INSTR.
Before programming, acquire the correct VISA descriptor.
The topics of this chapter:
 Programming Preparations
 Excel Programming Demo
 LabVIEW Programming Demo
 Matlab Programming Demo
 Visual Basic 6.0 Programming Demo
 Visual C++ 6.0 Programming Demo

Rigol MSO2000A Series Specifications

General

Brand	Rigol
Model	MSO2000A Series
Category	Test Equipment
Language	English