Related to auto Arm/Disarm operation.
YES: For any partition(s) set up for Auto Arming, an audible Exit Delay (warning)
countdown will commence 4.25 minutes prior to the automatic arming. During this
period, Exit Delay beeps will be heard.
You can enter a valid user code at any time during the countdown to delay the partition's
automatic arming by 45 minutes.
When an "Auto-Arm" partition is disarmed as described above, it can no longer be
automatically armed during the current day.
The extended 4.25 minutes warning does not apply to automatic Partial Arming.
NO: Auto Arming for any programmed partition(s) takes place at the designated time.
The programmed Exit Delay period and any audible signal occur as expected.
This option contains parameters that relate to what happens to the Installer, Sub-Installer
and Grand Master codes if the main panel's DEFAULT Dip Switch is in place when
power to the main panel is switched off and then on.
YES: The Installer, Sub-Installer and Grand Master codes will return to the original,
factory default values.
NO: The Installer, Sub-Installer and Grand Master codes will NOT return to the original,
factory default values by an unauthorized user.
Main Button: Status-Y/Talk-N parameter determines the function of the button on
the keypad.
YES: Status button – the system will relay the system status.
NO: Not applicable.
Enables the button on the surface of the main panel to perform quick allocation of
wireless devices. (See Quick Device Allocation at the Main Panel, page 23.)
YES: Quick Learn mode is enabled. A long press on the main panel button will start the
Learn mode, and the LEDs on the main panel will start flashing one after the other.
NO: Quick Learn mode is disabled. The main panel is not in Quick Learn mode.
To Next Page
Loading...
