Changes the system operation to Area instead of Partition, which then changes only the
operation of a common zone.
YES: When selected, the following points are relevant:
• A common zone will be armed after any partition is armed
• A common zone will be disarmed only when all partitions are disarmed
NO: When selected, the following points are relevant:
• A common zone will be armed only when all partitions are armed
• A common zone will be disarmed when any partition is disarmed
YES: Specifies that all zones (that are programmed to follow an Exit/Entry Delay time)
will follow the Exit/Entry Delay time of any armed partition.
NO: Specifies that all zones (that are programmed to follow an Entry Delay time) will
follow the Entry Delay time of only the partitions to which they are assigned.
YES: The system automatically sets its time of day clock one hour ahead in the spring (on
the last Sunday in March) and one hour back in the Autumn (on the last Sunday in
October).
NO: No automatic time accommodation is made.
YES: It is possible for the user to bypass a 24-hour zone.
Note: When set, this parameter also applies to the zone’s associated tamper settings. Thus, bypassing a
zone, also bypasses its tamper.
NO: It is not possible for the user to bypass a 24-hour zone.
YES: It is necessary to enter the installer code to reset a tamper alarm. Therefore, resetting
a tamper alarm requires the intervention of the alarm company. However, the system can
still be set.
NO: Correcting the problem resets a tamper alarm, requiring no alarm company
intervention.
To Next Page
Loading...
