Risco RW332M - Page 70

Page 64
RWX78SMU Detector Parameters (for 2 way Magnetic Contact, Shock and Universal detectors)
Magnet
LED Enabled
Yes
Yes/No
Defines the LED operation mode.
Yes: Detector's LED activated
No: Detector's LED deactivated
Hold On
On
On/Off
Use this parameter to define the minimum period between alarm
transmissions.
ON: Only one alarm message is transmitted in any 2.5-minute time-period
OFF: Alarm detection is immediately transmitted.
Shock
Shock
Enabled
Enabled/Disabled
Defines whether to enable or disable shock detection
LED Enabled
Yes
Yes/No
Defines the LED operation mode.
Yes: Detector's LED activated
No: Detector's LED deactivated
Shock Sensitivity
TBD
0-100%
Defines the detector’s level of sensitivity.
Universal
Universal
Enabled
Enabled/Disabled
Defines whether to enable or disable the universal zone input.
LED Enabled
Yes
Yes/No
Defines the LED operation mode.
Yes: Detector's LED activated
No: Detector's LED deactivated
External Zone
NO/NC/DEOL/Shutter
Defines the termination of the external zone input.
Response Time
10/500 ms
Define the response time of the external zone input (applicable for NO and
NC terminations only).
Hold On
On
On/Off