Rockwell Automation Allen-Bradley PanelView 800 User Manual

160 Rockwell Automation Publication 2711R-UM001I-EN-E - February 2023
Appendix E PanelView Explorer
Import a Font File You can import a Microsoft Windows CE font to your terminal. Other font files
are not supported.
During the import, the font file is transferred from a USB drive or microSD
card to the internal storage of the terminal. The transfer operation
communicates with the terminal to transfer the file.
You can use the imported font in any application on the terminal.
Follow these steps to add a font to the terminal.
1. Open the PanelView Explorer Startup window.
2. Click File Transfer.
3. Click New Transfer.
4. Select the source location of the Font file, typically My Computer, and
click Next.
5. Select Font as the file type and click Next.
6. Click Browse … to locate and select the Font file, then click Open.
7. Select Internal Storage as the destination for the font file and click
Transfer.
8. Observe the informational message for Transferring File.
9. The terminal should be rebooted to load the added font.
Remove a Font File A font that was added to the terminal and is no longer used can be removed.
Follow these steps to remove a font from the terminal.
1. Open the PanelView Explorer Startup window.
2. Click File Transfer.
3. Click Delete File.
4. Select the source location of the Font file, typically Internal Storage, and
click Next.
5. Select Font as the file type and click Next.
Observe the list of all Font files that have been added to the Terminal.
6. Select the Font file that you want to delete and click Delete.
7. Observe the Confirmation message for the selected Font file and click
OK.
8. Observe the informational message Deleting File.
Fonts cannot be exported for copyright reasons.
IMPORTANT The PanelView Explorer feature is only supported on PanelView 800
terminals with firmware revision 2.020 or earlier. It is not supported
from firmware revision 3.011 onwards.
Font files cannot be imported from PanelView Explorer when using
firmware revision 3.011 or later.
IMPORTANT The PanelView Explorer feature is only supported on PanelView 800
terminals with firmware revision 2.020 or earlier. It is not supported
from firmware revision 3.011 onwards.
Font files cannot be imported from PanelView Explorer when using
firmware revision 3.011 or later.

Rockwell Automation Allen-Bradley PanelView 800 Specifications

General

Brand	Rockwell Automation
Model	Allen-Bradley PanelView 800
Category	Touch terminals
Language	English