46 Rockwell Automation Publication 2711R-UM001I-EN-E - February 2023
Chapter 3 DesignStation in Connected Components Workbench Software
Install the Software To use the Connected Components Workbench software effectively your
computer should meet the following hardware requirements:
DesignStation in Connected Components Workbench software is supported
on the following operating systems:
• Windows® Server 2012
(a)
• Windows Server 2012 R2
• Windows Server 2016
(a)
• Windows Server 2019
• Windows 10 IoT Enterprise 2016 LTSB 64-bit
• Windows 10 IoT Enterprise 2019 LTSC
•Windows 10
•Windows 11
(b)
Your computer information can be found by right-clicking My Computer and
then selecting Properties.
Follow these steps to install Connected Components Workbench software.
Connected Components Workbench software version 11 is used in the
following examples.
1. Run the executable file.
Minimum System Requirements
Component Requirement
Processor Intel Pentium 4 2.8 GHz or equivalent
RAM Memory 2 GB
Hard disk space 10 GB free
Optical Drive DVD-ROM
Pointing Device
A
ny Microsoft Windows compatible pointing device
Recommended System Requirements
Component Requirement
Processor Intel Core i5 2.4 GHz or equivalent
RAM Memory 8 GB or more
Hard disk space 10 GB free or more
Optical Drive DVD-ROM
Pointing Device Any Microsoft Windows compatible pointing device
(a) Requires Connected Components Workbench software version 20 or earlier.
(b) Requires Connected Components Workbench software version 20 or later.
IMPORTANT All supported operating systems require .NET Framework 3.5 SP1 to be
installed.
To Next Page
Loading...
Need help?
General
