32 Rockwell Automation Publication 2711R-UM001I-EN-E - February 2023
Chapter 2 Configure the Terminal
permissions must be configured in Connected Components Workbench
software. See Configure FTP Settings
on page 57.
After you have established an FTP connection to the terminal, you can copy the
contents of the folders out from the terminal to your PC. The FTP server on the
terminal is disabled by default.
Follow these steps to enable the FTP server.
1. Go to the Terminal Settings screen.
2. Press Communication.
The Alarm History folder contains only the alarm history of the current running
application on the terminal.
IMPORTANT The terminal supports only one FTP connection. If another connection
is attempted, it is rejected and no notification is given. The behavior
varies from one FTP client to another.
IMPORTANT An FTP connection cannot be established while the terminal is loading
an application. Wait until the application has finished loading before
connecting to the terminal.
IMPORTANT It is recommended to download files from the terminal one at a time.
Also, set the connection inactivity timeout for your FTP client to 60
seconds or longer to avoid unsuccessful file download.
IMPORTANT The FTP server feature is not available for CompactLogix™ 5370 and
CompactLogix 5380 controllers.
IMPORTANT The VNC feature is only supported on PanelView 800 terminals
with firmware revisions 4.011…7.011.
For more information, contact your local technical support at
rok.auto/phonesuppo
rt.
Communication
Disable DHCP
Set Static IP Address
VNC Settings
Port Settings
FTP Settings
Back
PV800T7T
0
Protocol: *
Status: Unavailable
Device Name:
Node Address:
IP Mode: DHCP
IP Address: 0.0.0.0
Mask: 0.0.0.0
Gateway: 0.0.0.0
MAC Address: XX:XX:XX:XX:XX
To Next Page
Loading...
Need help?
General
