PowerFlex® 700L Liquid-Cooled Drive User Manual
Publication 20L-UM001D-EN-P
Chapter 2
Frame 2 Installation
Most start-up difficulties are the result of incorrect wiring. Every precaution
must be taken to assure that the wiring is done as instructed. All items must
be read and understood before actual installation begins.
Mounting Considerations
Total Area Required for Drive Installation
Overall drive dimensions are illustrated in Figure 2.1 as an aid in calculating
the total area required for installing Frame 2 drives.
For information on… See page…
Mounting Considerations
2-1
Equipment Lifting 2-3
Mounting Requirements 2-6
Verifying the Drive’s Watts Loss Rating 2-7
Removing the Drive Cover 2-7
Removing the Active Converter Control Cassette 2-7
Removing the Inverter Control Cassette 2-8
Determining Wire Routing for Control, Ground, Drive Input, and Motor Output 2-9
Grounding the Drive 2-11
Ungrounded or Resistive Grounded Installations 2-11
Power Wiring 2-12
Control Wiring 2-18
Synchronization Connections 2-20
DPI Connections for Frame 2 Drives 2-22
Coolant Loop Connections 2-22
!
ATTENTION: The following information is merely a guide for
proper installation. Rockwell Automation, Inc. cannot assume
responsibility for the compliance or the noncompliance to any
code, national, local or otherwise for the proper installation of
this drive or associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are ignored during
installation.
To Next Page
Loading...
Need help?
General
