R&S®SML / R&S®SMV03 Contents
1090.3123.12 9 E-6
Tables
Table 4-1
Overview of internal calibration routines ...................................................................... 4.62
Table 5-1 Synchronization by means of *OPC, *OPC? and *WAI ............................................... 5.15
Table 5-2 Meaning of the bits used in the status byte.................................................................. 5.19
Table 5-3 Meaning of the bits used in the event status register................................................... 5.20
Table 5-4 Resetting of instrument functions................................................................................. 5.24
Table 5-5 Interface functions........................................................................................................ 5.26
Table 5-6 Universal commands ................................................................................................... 5.27
Table 5-7 Addressed commands ................................................................................................. 5.27
Table 5-8 Control characters for RS-232-C interface .................................................................. 5.29
Table 6-1 Common Commands..................................................................................................... 6.3
Table 6-2 Device Response to *OPT? ........................................................................................... 6.4
Table 9-1 Error messages of hardware monitoring........................................................................ 9.8
Table 9-2 Error messages as a result of loss of data .................................................................... 9.8
Table 10-1 Maximum frequencies.................................................................................................. 10.1
Table 10-2 Measuring equipment and accessories ....................................................................... 10.2
Table 10-3 Measuring the frequency setting time .......................................................................... 10.7
Table 10-4 Performance test report ............................................................................................. 10.34
Table 10-5 Measuring equipment and accessories ..................................................................... 10.38
Table 10-6 Performance Test Report .......................................................................................... 10.49
To Next Page
Loading...
