Rohde & Schwarz SML01 - Stereo Modulation (Option R&S SML-B5); Fig. 4-16 Modulation - Stereo Menu (Preset Setting), Equipped with Option R&S SML-B5

R&S®SML / R&S®SMV03 Stereo Modulation (Option R&S SML-B5)
1090.3123.12 4.17 E-6
Stereo Modulation (Option R&S SML-B5)
For stereo modulation external modulation sources or the internal LF generator can be used. For analog
modulation signals, input connectors R and L are available at the rear panel. A digital stereo signal can
be attached to the S/P DIF input (i. g. the output signal from the Audio Analyzer UPL). The above-
mentioned different modulation sources cannot be used simultaneously.
In any case standard ARI and RDS signals can be generated, too.
Settings for stereo modulation can be made in the Modulation - Stereo menu.
Menu selection: Modulation – Stereo
Fig. 4-16 Modulation - Stereo menu (preset setting), equipped with option R&S SML-B5
Deviation
Input value of the frequency deviation of the stereo signal.
IEC/IEEE-bus command :SOUR:STER:DEV 40kHz