Rohde & Schwarz SML01 - Source System; Source:am Subsystem

R&S®SML / R&S®SMV03 SOURce:AM
1090.3123.12 E-6 6.13
SOURce System
This system contains the commands to configure the RF signal source. Keyword SOURce is optional,
i.e., it can be omitted. The LF signal source is configured in the SOURce2 system.
The following subsystems are realized in the instrument:
Subsystem Settings
[:SOURce]
:AM
:CORRection
:DM
:FM
:FREQuency
:PHASe
:PM
:POWer
:PULM
:PULSe
:ROSCillator
:STEReo
:SWEep
Amplitude modulation
Correction of the output level
Vector modulation
Frequency modulation
Frequencies including sweep
Phase of the output signal
Phase modulation
Output level, level control and level correction
Pulse modulation
Pulse generator
Reference oscillator
Stereo modulation
Sweeps
SOURce:AM Subsystem
This subsystem contains the commands to control the amplitude modulation. An LF generator which
serves as internal modulation source is fitted in the instrument. Part of the settings is effected under
SOURce2.
Command Parameters Default
Unit
Remark
[:SOURce]
:AM
[:DEPTh]
:EXTernal
:COUPling
:INTernal
:FREQuency
:SOURce
:STATe
0 to100 PCT
AC | DC
0. 1 Hz to 1 MHz
EXTernal | INTernal | TTONe
ON | OFF
PCT
Hz
[:SOURce]:AM[:DEPTh] 0 to 100 PCT
The command sets the modulation depth in percent. *RST value is 30PCT
Example: :SOUR:AM:DEPT 15PCT