R&S®SML / R&S®SMV03 List of Error Messages
1090.3123.12 E-6 9.1
9 Error Messages
The present chapter contains the error messages (short-term and long-term messages) of the R&S
SML / R&S SMV03.
Short-term message
The short-term message is displayed in the status line. Part of it
overwrites the status indications and disappears after approx. 2 seconds
or in the case of a new entry.
The instrument shows, e.g., short-term messages if the attempt is made
to enter an overrange or if incompatible operating modes deactivate one
another.
Long-term message
The long-term message is displayed in the status line by means of the
message "Err". Pressing the [ERROR] key calls the ERROR page in
which the messages are entered. Several messages can be entered at
the same time. The long-term message remains existing until there is no
cause any more. The ERROR page is exited using the [BACK] key.
The ERROR page offers access to long-term messages if the [ERROR] key is pressed.
Fig. 9-1 ERROR page
Notes: - An error message "Err" does not necessarily point to a defect instrument. There are
various operating states which can cause an ERROR message, e.g. if the instrument is
set to external reference but no external reference is connected.
- Error -313 indicates the loss of calibration data and is also applicable in case of a cold
start (key [PRESET] is pressed during switch-on). The calibration values can be
restored with internal calibration routines. These routines are accessible via menu
Utilities - Calib (see section on calibration).
To Next Page
Loading...
