Basic Operating Steps R&S®SML / R&S®SMV03
1090.3123.12 E-6 3.2
Basic Operating Steps
To operate the instrument, menus are called in the display. All setting possibilities and the current
setting status are evident from the menus. All settings can be made by accessing the menus.
RF frequency and RF level can also be set without menu operation using keys [FREQ] and [LEVEL].
RF signal and modulation can also be switched on/off without menu operation using keys [RF ON/OFF]
and/or [MOD ON/OFF].
Calling the menus
Accessing the menus is effected using rotary knob [VARIATION], [SELECT] key and [BACK] key.
Rotary knob
Rotary knob [VARIATION] moves the menu cursor over the positions of a menu level
to be selected.
If a scrollbar is visible at the right-hand margin of a menu, the menu is larger than
the screen window. If the menu cursor is moved to the margin of the screen window,
the covered lines become visible.
If the rotary knob is pressed after a position has been selected, the lower menu level
or the respective settings are called. The rotary knob hence has the same function
as the [SELECT] key.
[SELECT] key
The [SELECT] key acknowledges the selection marked by means of the menu
cursor. Depending on the position, the next lower menu level or the the respective
setting is called.
[BACK] key
The [BACK] key
- returns the menu cursor to the next higher menu level; the menu cursor is shifted
to the left into the preceding column of the menu structure,
- resets the menu cursor from frequency or level value indication in the header field
into the menu field to the menu called last,
- closes the display pages called using keys [STATUS], [HELP] and [ERROR]
again.
Settings are accessed in the setting menus ending with the right-hand display margin.
Fig. 3-2 Modulation - AM Menu
To Next Page
Loading...
