R&S®SML / R&S®SMV03 Basic Operating Steps
1090.3123.12 E-6 3.3
Selection and Change of Parameters
Select parameter Set the menu cursor to the name of the parameter desired using the rotary
knob, e.g. to AM Depth in the AM menu, cf. Fig. 3-2.
Change setting
value
Select parameter.
Press [SELECT] key or rotary knob.
The menu cursor changes from the parameter selected in the left-hand
column of the setting menu to the setting value on the right, e.g. from AM
Depth to 15%, cf. Fig. 3-2.
Via value inputs
Press the first digit of the new value or minus sign.
The old value is deleted, the entry is indicated in the marked field.
Enter further digits.
Terminate the input using a unit key or, in the case of inputs in the base unit
or in the case of inputs without unit, using the [1x/Enter] key.
Press [BACK] key.
The menu cursor wraps back to the appropriate parameter.
Using rotary knob
Set the digit cursor (bright field) to the position of the setting value to be
varied using keys [] [].
Turn rotary knob.
The value is varied.
Note: RF frequency and RF level can also be varied in a step width
which can be defined arbitrarily, using the rotary knob. In the
respective setting menu (Frequency or Level), the step width is
entered as Knob Step User and the Knob Step set from Decimal
to User. To point to the fact that the step width has been
converted to the value programmed, the bright field as a symbol
of the digit cursor disappears in the respective value indication.
To Next Page
Loading...
