Rohde & Schwarz SML01 - Short Tutorial; Sample Setting for First Users

R&S®SML / R&S®SMV03 Sample Setting for First Users
1090.3123.12 E-6 2.1
2 Short Tutorial
The present chapter contains a short tutorial with sample settings allowing the users to operate
immediately the instrument.
Sample Setting for First Users
Setting frequency and level of the RF output signal
First frequency and level of the RF output signal are set via keys [FREQ] and [LEVEL] in the DATA
INPUT field:
- Frequency 500 MHz
- Level 10 dBm
Operating steps Explanations
PRESET
SELECT
MENU / V ARIATION
Reset the instrument to the defined
state.
005
FREQ
M
+
DATA INPUT
dBµV
Set the frequency to 500 MHz.
The menu cursor marks the
permanent frequency indication.
01
LEVEL
DATA INPUT
x1
ENTER
dB(m)
Set the level to 10 dBm.
The menu cursor marks the
permanent level indication.
BACK
Reset the menu cursor to the menu
field.