R&S®SML / R&S®SMV03 SOURce:ROSCillator
1090.3123.12 E-6 6.33
SOURce:ROSCillator Subsystem
This subsystem contains the commands to set the external and internal reference oscillator.
Command Parameters Default
Unit
Remark
[:SOURce]
:ROSCillator
[:INTernal]
:ADJust
[:STATe]
:VALue
:SOURce
ON | OFF
0 to +4095
INTernal | EXTernal
[:SOURce]:ROSCillator[:INTernal]
The commands to set the internal reference oscillator are under this node.
[:SOURce]:ROSCillator[:INTernal]:ADJust
The commands for frequency adjustment (fine-tuning of the frequency) are under this node.
[:SOURce]:ROSCillator[:INTernal]:ADJust[:STATe] ON | OFF
The command switches the frequency adjustment on or off.
Example: :SOUR:ROSC:INT:ADJ:STAT ON *RST value is OFF
[:SOURce]:ROSCillator[:INTernal]:ADJust:VALue 0 to +4095
The command indicates the frequency correction value (tuning value). For a detailed definition, cf.
Section "Reference Frequency Internal/External".
Example: :SOUR:ROSC:INT:ADJ:VAL 0 not influenced by *RST or PRESET
[:SOURce]:ROSCillator[:INTernal]:RLOop NORMal | NARRow
The command sets the bandwidth of the reference loop. Normal and Narrow are available.
Example: :SOUR:ROSC:INT:RLO NORM *RST value is NORM
[:SOURce]:ROSCillator:SOURce INTernal | EXTernal
The command selects the reference source.
INTernal The internal oscillator is used.
EXTernal The reference signal is fed externally.
Example: :SOUR:ROSC:SOUR EXT *RST value is INT
To Next Page
Loading...
