Rohde & Schwarz SML01 - Source:correction Subsystem

R&S®SML / R&S®SMV03 SOURce:CORRection
1090.3123.12 E-6 6.15
SOURce:CORRection Subsystem
The CORRection subsystem permits a correction of the output level. The correction is effected by
adding user-defined table values to the output level as a function of the RF frequency. In the SML, this
subsystem serves to select, transmit and switch on User-Correction tables (see Section "User
Correction (Ucor)" as well).
Command Parameters Default
Unit
Remark
[:SOURce]
:CORRection
[:STATe]
:CSET
:CATalog?
:FREE?
[:SELect]
:DATA
:FREQuency
:POINts?
:POWer
:POINts?
:DELete
:ALL
ON | OFF
"name of table"
9 kHz...F
max
{,9 kHz... F
max
}
+20 ... -20dB {,+20 ... -20dB }
"name of table"
Hz
dB
Query only
Query only
F
max
depending on model
Query only
Query only
[:SOURce]:CORRection[:STATe] ON | OFF
The command switches the table selected using SOUR:CORR:CSET on or off.
Example: :SOUR:CORR:STAT ON *RST value is OFF
[:SOURce]:CORRection:CSET
The commands to select and edit the Ucor tables are under this node.
[:SOURce]:CORRection:CSET:CATalog?
The command requests a list of Ucor tables. The individual lists are separated by means of
commas. This command is a query and has no *RST value.
Example: :SOUR:CORR:CAT? Answer: "UCOR1", "UCOR2", "UCOR3"
[:SOURce]:CORRection:CSET:FREE?
This command queries the free space in the Ucor table.
The command is a query and thus has no *RST value.
Example: :SOUR:CORR:FREE?