Rohde & Schwarz SML01 - Page 194

SOURce:CORRection R&S®SML / R&S®SMV03
1090.3123.12 E-6 6.16
[:SOURce]:CORRection:CSET[:SELect] "na
me of table"
The command selects a Ucor table. This command alone does not yet effect a correction. First
the table selected must be activated (cf. :SOUR:CORR:STAT). If there is no table of this name, a
new table is created. The name may contain up to 7 letters. This command triggers an event and
hence has no *RST value.
Example: :SOUR:CORR:CSET:SEL "UCOR1"
[:SOURce]:CORRection:CSET:DATA
The commands to edit the Ucor tables are under this node.
[:SOURce]:CORRection:CSET:DATA:FREQuency 9 kHz... F
max
{,9 kHz... F
max
} , F
max
depends on
model
The command transmits the frequency data for the table selected using :SOUR:CORR:CSET.
The frequency values must be entered in ascending order. *RST does not influence data lists.
Example: :SOUR:CORR:CSET:DATA:FREQ 100MHz,102MHz,103MHz,...
[:SOURce]:CORRection:CSET:DATA:FREQuency:POINts?
The command returns the number of list elements.
This command is a query and hence has no *RST value.
Example: :SOUR:CORR:CSET:DATA:FREQ:POIN?
[:SOURce]:CORRection:CSET:DATA:POWer +20 to -20dB {,+20 to -20dB }
The command transmits the level data for the table selected using :SOUR:CORR:CSET. *RST
does not influence data lists.
Example: :SOUR:CORR:CSET:DATA:POW 1dB, 0.8dB, 0.75dB,...
[:SOURce]:CORRection:CSET:DATA:POWer:POINts?
The command returns the number of list elements.
This command is a query and hence has no *RST value.
Example: :SOUR:CORR:CSET:DATA:POW:POIN?
[:SOURce]:CORRection:CSET:DELete "name of table"
The command deletes the table indicated from the instrument memory. This command triggers
an event and hence has no *RST value.
Example: :SOUR:CORR:CSET:DEL "UCOR3"