Rohde & Schwarz SML01 - Reset Values of Status Reporting System

Status Reporting System R&S®SML / R&S®SMV03
1090.3123.12 E-6 5.24
Reset Values of Status Reporting System
Table 5-4 lists the commands and events that cause a reset of the status reporting system. Except for
*RST and SYSTem:PRESet, none of the commands has an effect on the functional settings of the
instrument. It should be noted in particular that DCL also does not change instrument settings.
Table 5-4 Resetting of instrument functions
Event
Switching on of
AC supply voltage DCL, SDC
Power On Status
Clear
(Device Clear,
Selected Device
Clear)
*RS
T or
SYSTem:PRESet
STATus:PRESet *CLS
Effect 0 1
Clears STB, ESR

yes
  
yes
Clears SRE, ESE

yes
   
Clears PPE

yes
   
Clears EVENt parts of the
registers

yes
  
yes
Clears ENABle parts of all
OPERation and
QUESTionable registers,
fills ENABle parts of all
ot
her regi
sters with "1"

yes
 
yes

Fills PTRansition parts
with "1",
clears NTRansition parts

yes
 
yes

Clears error queue yes yes
  
yes
Clears output buffer yes yes yes 1) 1) 1)
Clears command
processing and input
buffer
yes yes yes
  
1) Each command which is the first in a command line, ie which directly follows the <PROGRAM MESSAGE TERMINATOR>, clears the output
buffer.