Rohde & Schwarz SML01 - TEST System

R&S SML TEST
1090.3123.12 E-6 6.49
TEST System
This system contains the commands to execute the selftest routines (RAM?, ROM? and BATT?) as well
as to directly manipulate the hardware modules (:TEST:DIR). The selftests return a "0" if the test has
been executed successfully, otherwise a value unequal to "0". All commands of this system do not have
an *RST value.
Caution: The commands under node :TEST:DIR directly act on the respective hardware module
circumventing any security mechanisms. They are provided for service purposes and
should not be used by the user. Improper use of the commands may damage the module.
Command Parameters
Default
Unit
Remark
:TEST
:DIRect
:ASSy
:RAM?
:ROM?
:BATTery?
Address, subaddress, hex data string
Module, subaddress, hex data string
Query only
Query only
Query only
:TEST:DIRect Address, subaddress, hex data string
This node contains the commands directly acting on the respective hardware module
circumventing any security mechanisms. The commands under this node have no short form.
:TEST:ASSy Module, subaddress, hex data string
This command addresses the ASSy module. A subaddress (0 or 1) must be entered as a
parameter. The data are entered as a <string> (ie an ASCII character string enclosed in inverted
commas) representing hexadecimal numbers. The string, therefore, may contain the characters
0 to 9 A to F.
:TEST:RAM?
The command triggers a test of the RAM.
:TEST:ROM?
The command triggers a test of the main memory (EEPROM).
:TEST:BATTery?
The command triggers a test of the battery voltage.