SYSTem R&S®SML / R&S®SMV03
1090.3123.12 E-6 6.46
SYSTem System
In this system, a number of commands for general functions which are not immediately related to signal
generation, are combined.
Command Parameters Default
Unit
Remark
:SYSTem
:COMMunicate
:GPIB
[:SELF]
:ADDRess
:SERial
:BAUD
:BITS
:SBITs
:CONTrol
:RTS
:PACE
:PARity
:DISPlay
:UPDate
[:STATe]
:ERRor?
:PRESet
:PROTect[1|2|3|4]
[:STATe]
:SECurity
[:STATe]
:SERRor?
:VERSion?
1 to 30
1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 |
115200
7 | 8
1 | 2
ON | IBFull | RFR
XON | NONE
ODD | EVEN | NONE
ON | OFF
ON | OFF, password
ON | OFF
Query only
No query
Query only
Query only
:SYSTem:COMMunicate
The commands to set the remote control interfaces are under this node.
:SYSTem:COMMunicate:GPIB
The commands to control the IEC bus are under this node (GPIB = G
eneral Purpose Interface Bus).
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess 1 to 30
The command sets the IEC bus instrument address. *RST value is 28
Example: :SYST:COMM:GPIB:ADDR 1
:SYSTem:COMMunicate:SERial
The command to set the serial interface are under this node. The data format is fixedly set to 8
data bits, no parity and 1 stop bit. These values cannot be changed. The device represents a DTE
(Data Terminal Equipment) in relation to the serial interface. Therefore the the controller must be
connected via a 0-modem.
To Next Page
Loading...
