Rohde & Schwarz SML01 - Level Sweep; Fig. 4-20 Sweep - Level Menu

R&S®SML / R&S®SMV03 Sweep
1090.3123.12 E-6 4.53
Level Sweep
Settings for level sweeps can be made in the Sweep - Level menu.
Menu selection: Sweep - Level
Fig. 4-20 Sweep - Level menu
Start Level
Input value of start level.
IEC/IEEE-bus command :SOUR:POW:STAR -30dBm
Stop Level
Input value of stop level.
IEC/IEEE-bus command :SOUR:POW:STOP -10dBm
Current Level
Display of current level.
In Step mode: Input value of level.
Step
Input value of step width.
IEC/IEEE-bus command :SOUR:SWE:POW:STEP 1dB
Dwell
Input value of dwell time per step.
IEC/IEEE-bus command :SOUR:SWE:POW:DWEL 15ms
Mode
Selection of sweep mode (see "Operating Modes").
IEC/IEEE-bus command :SOUR:POW:MODE SWE;
:SOUR:SWE:POW:MODE AUTO;
:TRIG:SOUR SING
Reset Sweep
Sets the start level.
IEC/IEEE-bus command :ABOR
Exec Single Sweep
Starts a single sweep. This function is displayed and is effective
only if Single Mode is selected.
IEC/IEEE-bus command :TRIG