R&S®SML / R&S®SMV03 RF Frequency
1090.3123.12 4.1 E-6
4 Instrument Functions
This chapter describes the functions of the instrument and its options which can be activated manually
via menus or by remote control (frequency and level settings, analog modulations, sweep, and general
functions not directly related to signal generation).
RF Frequency
The RF frequency can be set directly using the [FREQ] key or via the Frequency menu. In the
Frequency menu, the frequency of the RF output signal is entered and indicated under Frequency.
In frequency settings made with the [FREQ] key, an arithmetic offset is taken into account. Such
settings are indicated in the header line of the display. This makes it possible to enter the desired output
frequency of subsequent units, if any (eg mixers). The offset can also be entered in the Frequency
menu (see next section: "Frequency Offset").
Note: Further settings: Frequency sweep Sweep menu
LF frequency Modulation menu
LFOutput menu
Int./ext. reference frequency Utilities - Ref Osc menu
Menu selection: Frequency
Fig. 4-1 Frequency menu
Frequency
Input value of RF frequency at RF output connector.
IEC/IEEE-bus command :SOUR:FREQ 100E6
Offset
Input value of frequency offset, for example of subsequent mixer.
IEC/IEEE-bus command :SOUR:FREQ:OFFS 0
Extended Divider
Range
Off Normal operation. The extended divider range is deactivated.
IEC-Bus-Befehl :SOUR:FREQ:ERAN OFF
On The extended divider range is activated.
IEC/IEEE-bus command :SOUR:FREQ:ERAN ON
Knob Step User
Input value of step size of frequency variation via rotary knob. The RF frequency
is varied by the entered step size if Knob Step is set to User.
IEC/IEEE-bus command :SOUR:FREQ:STEP 1MHz
To Next Page
Loading...
