Utilities R&S®SML / R&S®SMV03
1090.3123.12 E-6 4.64
Display of Voltages of Test Points (Diag - TPoint)
Access to internal test points is offered by the Diag - TPoint submenu. If a test point is switched on, the
voltage is displayed in a window in the header field. For more detailed information see Service Manual.
Menu selection: Utilities - Diag - TPoint
Fig. 4-33 Utilities - Diag - TPoint menu
State
Switching on/off the voltage display in the header field.
Test Point
Input value of test point.
IEC/IEEE-bus command :DIAG:POIN? xxxx
To Next Page
Loading...
