Rohde & Schwarz SML01 - Sweep Inputs; Run; RF Sweep; Fig. 4-19 Sweep - Freq Menu

R&S®SML / R&S®SMV03 Sweep
1090.3123.12 E-6 4.51
Ext Step
St
ep-by-step run controlled by an external trigger signal. Each trigger event triggers
a single step.
IEC/IEEE-bus commands:
RF sweep: LF sweep: Level sweep:
SOUR:FREQ:MODE SWE SOUR2:FREQ:MODE SWE SOUR:POW:MODE SWE
SOUR:SWE:MODE STEP SOUR2:SWE:MODE STEP SOUR:SWE:POW:MODE STEP
TRIG:SOUR EXT TRIG2:SOUR EXT TRIG:SOUR EXT
Off
Switching-off sweep mode.
IEC/IEEE-bus commands:
RF sweep: LF sweep: Level sweep:
SOUR:FREQ:MODE CW SOUR2:FREQ:MODE CW SOUR:POW:MODE CW
Sweep Inputs
TRIGGER
An external signal at the rear input triggers the sweep in the Ext Single and Ext Step
modes or stops the sweep in all modes.
RUN
Queries whether a sweep is being performed.
IEC/IEEE bus commands: RF sweep: LF sweep: Level sweep:
SOUR:SWE:RUNN? SOUR2:SWE:RUNN? SOUR:SWE:POW:RUNN?
Note: This query may cause distortions in the course of the sweep, depending on the frequency
of checkimng and dwell time.
RF Sweep
Settings for RF sweeps can be made in the Sweep - Freq menu.
Menu selection: Sweep – Freq
Fig. 4-19 Sweep - Freq menu