R&S®SML / R&S®SMV03 Test sequence
1147.7621.12 10.43 E-6
Level
Level frequency response and linearity
Test method for level in measurement range of power meter (up to approx. - 22 dBm)
Test equipment See Performance test R&S SML03 / R&S SMV03.
Test setup
See Performance test R&S SML03 / R&S SMV03.
Settings on
R&S SMV03
- VECTORMOD STATE IQCW
- FREQ Test frequency level accuracy
- Test frequencies: 5 MHz, 5,1 MHz, 76 MHz, 77 MHz, 151 MHz,
255 MHz, 302 MHz, 605 MHz, 606 MHz, 725 MHz, 970 MHz, f
max
,
1210.5 MHz, 1211 MHz, 1818 MHz, 2000 MHz, 2200 MHz, 2800
MHz, 3000 MHz, 3300 MHz
- LEVEL Test level 1 level accuracy
- Test level 1: 8 dBm, 3.1 dBm, 3 dBm, -2 dBm, -7 dBm,
-12 dBm, -17 dBm, -21.9 dBm, -22.0 dBm
Settings on powermeter See Performance test R&S SML03 / R&S SMV03
Measurement See Performance test R&S SML03 / R&S SMV03.
Measurement procedure for low levels (>-115 dBm)
Caution: The precondition for correct measurement is that the used components are wholly
RF-shielded.
Test Method see Performance test R&S SML03 / R&S SMV03.
Settings on R&S SMV03 - VECTORMOD STATE IQCW
- Test frequencies >=5MHz
Setting time
Test setup Test setup 2 (see Performance test R&S SML03 / R&S SMV03)
Test method See Performance test R&S SML03 / R&S SMV03
Preparing measurement See Performance test R&S SML03 / R&S SMV03
Settings on R&S SMV03 - VECTORMOD STATE IQCW
- FREQ Test frequency setting time
MeasurementMessung See Performance test R&S SML03 / R&S SMV03
Non-interrupting level setting (ATTENUATOR FIXED)
Tset setup Test setup 1 with spectrum analyzer (Performance test R&S
SML03 / R&S SMV03)
Settings on R&S SMV03 - VECTORMOD STATE IQCW
- FREQ Test frequencies ATT-FIX
- Test frequencies: 100 kHz, 5,1 MHz, f
max
, 1211 MHz.
2200 MHz, 3300 MHz
- LEVEL 3.1 dBm
- LEVEL LEVEL ATTENUATOR MODE FIXED
Measurement See Performance test R&S SML03 / R&S SMV03
To Next Page
Loading...
