R&S®SML / R&S®SMV03 List Editor
1090.3123.12 E-6 3.11
Fill editing function (s
ee Fig. 3-7)
The Fill function overwrites a parameter with constant or linearly increasing/decreasing values within a
defined range. If the [BACK] key is pressed, the editing window will be exited without any change being
made.
If the fill range extends beyond the end of the list, the list is automatically extended.
Filling of a list is done in the same way as the insertion of elements in a list, see "Insert editing function".
Selection: Fill
Fig. 3-7 Fill editing function
Fill At
Input of start index.
Range
Number of elements to be included.
Parameter
Selection of parameters (frequency, power) to be filled. This menu option is not
offered if a list contains only elements with one parameter.
Start Frequency
Input of start value for the selected parameter. This option is offered only if
Frequency is selected as a parameter.
Increment Frequency
Input of increment between two successive values. If 0 is entered as an
increment, the list will be filled with identical values. This option is offered only
if Frequency is selected as a parameter.
Power
Input of start value for the selected parameter. This option is offered only if
Power is selected as a parameter.
Increment Power
Input of increment between two successive values. If 0 is entered as an
increment, the list will be filled with identical values. This option is offered only
if Power is selected as a parameter.
Execute
Starts the filling procedure. After the execution of the function, the menu cursor
goes back to Edit List.
To Next Page
Loading...
