Rohde & Schwarz SML01 - Abort System; Calibration System

ABORt / CALibration R&S®SML / R&S®SMV03
1090.3123.12 E-6 6.6
ABORt System
The ABORt system contains the commands to abort actions triggered. After an action has been aborted, it
can be triggered again at once. All commands trigger an event, thus they have no *RST value. Further
commands for the trigger system of the R&S SML / R&S SMV03 can be found in the TRIGger system.
Command Parameter Default
Unit
Remark
:ABORt
[:SWEep]
No query
:ABORt[:SWEep]
The command restarts a sweep.
Example: :ABOR:SWE
CALibration System
The CALibration System contains the commands for external calibrations. For calibration of Ref Osc
see Service Manual.
Command Parameter Default
Unit
Remark
:CALibration
[:ALL]
:ATTenuator
:STATe
<numeric>, ON | OFF
:FMOFfset
[:MEASure]?
:HARMfilter
[:MEASure]?
:IFFilter
[:MEASure]?
:LEVel
:STATe
<numeric>, ON | OFF
:LFGenlevel
[:MEASure]?
:LPReset
[:MEASure]?
:MAINloop
[:MEASure]?
:MULTfilter
[:MEASure]?
:ROSCillator
[:DATA]?
:STORe
[ MAXimum | MINimum ]
VMODulation
[:MEASure]?
[ ONCE ]
:CALibration:LEVel:STATe
The command switches level correction ON or OFF.
Example: :CAL:LEV:STAT ON *RST value is ON