R&S®SML / R&S®SMV03 Common Commands
1090.3123.12 6.5 E-6
*RCL 1 to 50
RECALL calls the instrument state which was stored under the number supplied using command
*SAV. 50 instrument states can be stored.
*RST
RESET sets the instrument to a defined default status. The command essentially corresponds to
pressing the [PRESET] key. The state of the RF-output is an exception: The RF-output is
deactivated after *RST, however, it is activated after the [PRESET] key has been pressed. The
default setting is indicated in the description of the commands.
*SAV 1 to 50
SAVE stores the current instrument state under the number indicated (cf. *RCL as well).
*SRE 0 to 255
SERVICE REQUEST ENABLE sets the service request enable register to the value indicated. Bit
6 (MSS mask bit) remains 0. This command determines under which conditions a service request
is triggered. Query *SRE? reads the contents of the service request enable register in decimal
form. Bit 6 is always 0.
*STB?
READ STATUS BYTE QUERY reads out the contents of the status byte in decimal form.
*TRG
TRIGGER triggers all
actions waiting for a trigger event. Special trigger events can be started by
command system "TRIGger" (see section "TRIGger System").
*WAI
WAIT-to-CONTINUE only permits the servicing of the subsequent commands after all preceding
commands have been executed and all signals have settled (cf. "*OPC" as well).
To Next Page
Loading...
