Rohde & Schwarz SML01 - Page 13

R&S®SML / R&S®SMV03 Contents
1090.3123.12 11 E-6
Fig. 4-26
Utilities – System – RS232 menu.................................................................................4.57
Fig. 4-27 Utilities – System – Security menu...............................................................................4.58
Fig. 4-28 Utilities – RefOsc menu (preset setting) ......................................................................4.59
Fig. 4-29 Menu Utilities – Phase .................................................................................................4.60
Fig. 4-30 Utilities - Protect menu (preset setting)........................................................................4.61
Fig. 4-31 Utilities - Calib menu (preset setting) ...........................................................................4.62
Fig. 4-32 Utilities - Diag - Config menu .......................................................................................4.63
Fig. 4-33 Utilities - Diag - TPoint menu .......................................................................................4.64
Fig. 4-34 Utilities - Diag - Param menu .......................................................................................4.65
Fig. 4-35 Utilities - Test menu .....................................................................................................4.66
Fig. 4-36 Utilities - ModKey menu (preset setting) ......................................................................4.67
Fig. 4-38 STATUS menu.............................................................................................................4.69
Fig. 5-1 Tree structure of SCPI command systems using the SOURce system
as an example................................................................................................................5.7
Fig. 5-2 Device model for remote control via the IEC/IEEE bus ...............................................5.13
Fig. 5-3 Status register model ...................................................................................................5.16
Fig. 5-4 Overview of status registers.........................................................................................5.18
Fig. 5-5 Pin assignment of IEC/IEEE-bus interface ..................................................................5.25
Fig. 5-6 Pin assignment of RS-232-C interface.........................................................................5.28
Fig. 5-7 Wiring of data, control and signalling lines for hardware handshake...........................5.30
Fig. 9-1 ERROR page .................................................................................................................9.1