SOURce:SWEep R&S®SML / R&S®SMV03
1090.3123.12 E-6 6.40
SOURce]:SWEep:POWer:RUNNing?
The c
ommand set a queries whether a sweep is being performed.
Example: SOUR:SWE:POW:RUNN?
Note: This query may cause distortions in the course of the sweep, depending on the frequency
of checkimng and dwell time.
[:SOURce]:SWEep:POWer:SPACing LOGarithmic
The command defines that the sweep steps have logarithmic spacings. It permits the query of
SPACing.
Example: :SOUR:SWE:POW:SPAC LOG *RST value is LOG
[:SOURce]:SWEep:POWer:STEP[:LOGarithmic] 0 to 160 dB
The command indicates the step width factor for logarithmic sweeps. The next level value of a
sweep is calculated according to
new level = previous level + STEP:LOG
Usually :STEP:LOG is entered in units of dB,. A change of STARt or STOP does not result in a
change of :STEP:LOG. Keyword :LOG can be omitted, then the command conforms to SCPI
regulation (see example).
Example: :SOUR:SWE:POW:STEP 10dB *RST value is 1dB
To Next Page
Loading...
