SOURce2:FREQuency R&S®SML / R&S®SMV03
1090.3123.12 E-6 6.42
:SOURce2:FREQuency:MODE CW
| FIXed | SWEep
The command specifies the operating mode and hence by means of which commands the
FREQuency subsystem is controlled. The following allocations are valid:
CW | FIXed CW and FIXed are synonyms. The output frequency is specified by means of
SOUR2:FREQ:CW |FIX.
SWEep The generator operates in the SWEep mode. The frequency is specified by means
of commands :SOUR2:FREQ:STAR; STOP; MAN.
Example: :SOUR2:FREQ:MODE CW *RST value is FIX
SOURce2:SWEep:[:FREQuency]:RUNNing?
The command set a queries whether a sweep is being performed.
Example: SOUR:SWE:FREQ:RUNN?
Note: This query may cause distortions in the course of the sweep, depending on the frequency
of checkimng and dwell time.
:SOURce2:FREQuency:STARt 0.1 Hz to 1 MHz
This command defines the starting value of the frequency for the sweep.
Example: :SOUR2:FREQ:STAR 1kHz *RST value is 1 kHz
:SOURce2:FREQuency:STOP 0.1 Hz to 1 MHz
This command defines the end value of the frequency for the sweep.
Example: :SOUR2:FREQ:STOP 200kHz *RST value is 100 kHz
To Next Page
Loading...
