Rohde & Schwarz SMW-K144 - Page 243

Remote-Control Commands
R&S
®
SMW-K144
243User Manual 1178.8013.02 ─ 06
Parameters:
<VrbToPrb> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 1_0" on page 112
See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:DAI2 <DAI2>
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:DAI1 <DAI1>
Sets the DCI filed DL assignment index.
Parameters:
<DAI1> integer
Range: 0 to 3
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_1" on page 110
See "DCI Format 1_0" on page 112
See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:ANTPorts <AntPorts>
Sets the DCI field antenna ports.
Parameters:
<AntPorts> integer
Range: 0 to 31
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_1" on page 110
See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:SRSRequest <SRSRequest>
Sets the DCI field SRS request.
CORESET Commands