Rohde & Schwarz SMW-K144 - Page 242

Remote-Control Commands
R&S
®
SMW-K144
242User Manual 1178.8013.02 ─ 06
Parameters:
<RVTB2> integer
Range: 0 to 3
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_0" on page 109
See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:HAPRoc <HarqProc>
Sets the DCI field HARQ process number.
Parameters:
<HarqProc> integer
Range: 0 to 15
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_0" on page 109
See "DCI Format 0_1" on page 110
See "DCI Format 1_0" on page 112
See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:TPUSch <TpcPusch>
Sets the DCI field TPC command for scheduling PUSCH.
Parameters:
<TpcPusch> integer
Range: 0 to 3
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_0" on page 109
See "DCI Format 0_1" on page 110
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:VTPRb <VrbToPrb>
Sets the DCI field VRB-to-PRB mapping.
CORESET Commands