Rohde & Schwarz SMW-K144 - Page 59

5G New Radio Configuration and Settings
R&S
®
SMW-K144
59User Manual 1178.8013.02 ─ 06
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:CTYPe on page 190
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:CTYPe on page 190
Additional Position Index
Sets the parameter dmrs-AdditionalPosition that is required to select the posi-
tions of the DMRS symbols l
~
, as defined in TS 38.211.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:APINdex on page 190
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:APINdex on page 190
Max Length
Sets the parameter maxLength and defines whether single- or double-symbol DMRS
is used.
If "Max Length = 1", only single-symbol DMRS is allowed.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:MLENgth on page 190
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:MLENgth on page 190
Scrambling ID 0/Scrambling ID 1
Sets the higher-layer parameters scramblingID0 and scramblingID1 (N
ID
0
,N
ID
1
).
The values are used to calculate the initialization sequence of the pseudo-random
sequence generator.
See also "About PDSCH and DMRS sequence generation" on page 58.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:SID0 on page 191
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:SID1 on page 191
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:SID0 on page 191
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:SID1 on page 191
PTRS Config ...
Comprises the settings of the phase-tracking reference signals (PTRS) for PDSCH, as
defined in TS 38.214.
Users/BWPs Settings