Rohde & Schwarz SMW-K144 - Page 190

Remote-Control Commands
R&S
®
SMW-K144
190User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:PDSCh:DSID.... 193
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:PDSCh:
MCWDci............................................................................................................. 194
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:PDSCh:
MCSTable........................................................................................................... 194
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:PDSCh:VPINter.194
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:PDSCh:
RESalloc.............................................................................................................195
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:CTYPe <TypeBConfigType>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:CTYPe <TypeAConfigType>
Sets the configuration type (type 1 or type 2) and defines the mapping of the DMRS to
the physical resource elements.
Parameters:
<TypeAConfigType> T1 | T2
*RST: T1
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Config Type" on page 58
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:APINdex <TypeBAddPosIdx>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:APINdex <TypeAAddPosIdx>
Sets the parameter additional position idex, required to select the positions of the
DMRS symbols.
Parameters:
<TypeAAddPosIdx> integer
Range: 0 to 3
*RST: 0
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Additional Position Index" on page 59
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:MLENgth <TypeBMaxLength>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:MLENgth <DmrsMaxLength>
Sets if single- or double-symbol DMRS is used.
BWP Configuration Commands