Rohde & Schwarz SMW-K144 - Page 191

Remote-Control Commands
R&S
®
SMW-K144
191User Manual 1178.8013.02 ─ 06
Parameters:
<DmrsMaxLength> integer
Range: 1 to 2
*RST: 2
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Max Length" on page 59
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:SID0 <ScramID0>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:SID1 <ScramID1>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:SID0 <ScramID0>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:SID1 <ScramID1>
Sets the scrambling ID.
Parameters:
<ScramID1> integer
Range: 0 to 65535
*RST: 0
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Scrambling ID 0/Scrambling ID 1" on page 59
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:STATe <TypeAPtrsState>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:STATe <PtrsState>
Enables the transmission of phase-tracking reference signals.
Parameters:
<PtrsState> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "State" on page 60
BWP Configuration Commands