Rohde & Schwarz SMW-K144 - Page 192

Remote-Control Commands
R&S
®
SMW-K144
192User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:REOF <ResElemOffset>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:REOF <ResElemOffset>
Sets the parameter resource element offset.
Parameters:
<ResElemOffset> RE00 | RE01 | RE11 | RE10
*RST: RE00
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "RE-offset" on page 60
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:EPRE <EpreRatio>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:EPRE <PtrsEpreRatio>
Sets the parameter EPRE ratio.
Parameters:
<PtrsEpreRatio> RAT0 | RAT1
*RST: RAT0
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "EPRE Ratio" on page 61
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:MCS1 <PtrsImcs1>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:MCS2 <PtrsImcs2>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:MCS3 <PtrsImcs3>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:MCS1 <PtrsImcs1>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:MCS2 <PtrsImcs2>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:MCS3 <PtrsImcs3>
Sets the threshold values ptrs-MCS
I
with I = {1, 2, 3}.
Parameters:
<PtrsImcs3> integer
Range: 0 to 29
*RST: 0
BWP Configuration Commands