Rohde & Schwarz SMW-K144 - Page 60

5G New Radio Configuration and Settings
R&S
®
SMW-K144
60User Manual 1178.8013.02 ─ 06
Phase-tracking reference signals can be transmitted only in the resource blocks used
for the PDSCH and if the transmission is enabled.
State ← PTRS Config ...
If DSCH/USCH Channel Coding > "On", enables the transmission of phase-tracking
reference signals.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:STATe on page 191
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:STATe on page 191
RE-offset ← PTRS Config ...
Sets the parameter resourceElementOffset k
ref
RE
required to define the precoding
and mapping to the physical resources.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTA:PTRS:REOF on page 192
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DMTB:PTRS:REOF on page 192
Users/BWPs Settings