2
Basic
Operation
Setup of Media
59
5.
Deciding to perform the setting for cutting or not
[Only Printing]
Press
to select [NEXT].
Press
to enable the setting.
Go to Procedure
9
.
[Print & Cut]
Press
to select [SET].
Press
to enable the setting.
Go to Procedure
6
.
6.
Setting the blade force
Press to select [SET].
Press
to enable the setting.
The test pattern is cut. Circle and rectangle are cut. Peal o the
two shapes.
Continued on the next page
CUT CONFIG
[SET] NEXT
For high-quality cutting, perform a cutting test to check the cutting quality for the media and adjust
the blade force.
When Cutting the Printed Surface
Hardened ink is thick. When cutting a printed surface, rst perform a cutting test on the actual
surface that has been printed.
The end of the cap for the blade holder may scrape or damage the printed surface. If this happens,
increase the amount of blade extension.
P. 136, "Accurately Adjusting the Cutting-in Amount," p. 136, ”Adjusting the Conditions for Cutting the Printed
Surface/Cutting-in Amount”
CUT FORCE
[SET] NEXT
Circle
Rectangle
To Next Page
Loading...
