Reference Manual
00809-0100-4026, Rev FA
July 2009
Rosemount 5400 Series
www.rosemount.com
Section 1 Introduction
Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-1
Manual Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-3
Service Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-4
Product Recycling/Disposal . . . . . . . . . . . . . . . . . . . . . . . page 1-4
SAFETY MESSAGES Procedures and instructions in this manual may require special precautions to
ensure the safety of the personnel performing the operations. Information that
raises potential safety issues is indicated by a warning symbol ( ). Refer to
the safety messages listed at the beginning of each section before performing
an operation preceded by this symbol.
Failure to follow safe installation and service guidelines could result in death or
serious injury
• Make sure only qualified personnel perform installation or service.
• Use the equipment only as specified in this manual. Failure to do so may
impair the protection provided by the equipment.
• Any substitution of non-authorized parts or repair, other than exchanging the
complete transmitter head or antenna assembly, may jeopardize safety and is
prohibited.
• Unauthorized changes to the product are strictly prohibited as they may
unintentionally and unpredictably alter performance and jeopardize safety.
Unauthorized changes that interfere with the integrity of the welds or flanges,
such as making additional perforations, compromise product integrity and
safety. Equipment ratings and certifications are no longer valid on any products
that have been damaged or modified without the prior written permission of
Emerson Process Management. Any continued use of product that has been
damaged or modified without prior written authorization is at the customer's
sole risk and expense.
Explosions could result in death or serious injury
• Verify that the operating environment of the transmitter is consistent with the
appropriate hazardous locations specifications.
• In an Explosion-proof/Flameproof installation, do not remove the transmitter
cover when power is applied to the unit.
• Before connecting a
HART
®
based communicator in an explosive atmosphere,
make sure the instruments in the loop are installed in accordance with
intrinsically safe or non-incendive field wiring practices.
Electrical shock can result in death or serious injury
• Avoid contact with the leads and terminals. High voltage that may be present
on leads can cause electrical shock.
• Make sure the main power to the 5400 Series transmitter is off and the lines to
any other external power source are disconnected or not powered while wiring
the transmitter.
To Next Page
Loading...
