Reference Manual
00809-0100-4026, Rev FA
July 2009
Rosemount 5400 Series
5-6
Volume Configuration For volume calculations, choose one of the standard tank shapes or the
strapping option. Select None if volume calculation is not used. For the
standard tanks, a Volume Offset parameter can be specified which can be
used for a non-zero volume that corresponds to the zero level. This may be
useful, for example, if the user wants to include the product volume below the
zero level.
Volume calculation is performed by using a predefined tank shape or a
strapping table. One of the following standard tank shapes can be chosen:
• Sphere
• Vertical Cylinder
• Horizontal Cylinder
• Vertical Bullet
• Horizontal Bullet
The following parameters must be entered for a standard tank shape:
• Tank diameter
• Tank height (not for spherical tanks)
• Volume Offset
To Next Page
Loading...
