Reference Manual
00809-0100-4026, Rev FA
July 2009
Rosemount 5400 Series
www.rosemount.com
Section 7 Service and Troubleshooting
Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7-1
Troubleshooting Overview . . . . . . . . . . . . . . . . . . . . . . . . . page 7-3
Service Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7-4
Analyzing the Measurement Signal . . . . . . . . . . . . . . . . . page 7-4
Surface Pulse Not Found . . . . . . . . . . . . . . . . . . . . . . . . . .page 7-5
Using the Echo Curve Analyzer . . . . . . . . . . . . . . . . . . . . page 7-9
Analog Output Calibration . . . . . . . . . . . . . . . . . . . . . . . . . page 7-14
Logging Measurement Data . . . . . . . . . . . . . . . . . . . . . . . . page 7-14
Backing Up the Transmitter Configuration . . . . . . . . . . . page 7-15
Diagnostics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7-17
Configuration Report . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7-18
Viewing Input and Holding Registers . . . . . . . . . . . . . . . . page 7-18
Reset to Factory Settings . . . . . . . . . . . . . . . . . . . . . . . . . page 7-19
Surface Search . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7-20
Using the Simulation Mode . . . . . . . . . . . . . . . . . . . . . . . . page 7-20
Write Protecting a Transmitter . . . . . . . . . . . . . . . . . . . . . page 7-20
Diagnostic Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7-21
SAFETY MESSAGES Procedures and instructions in this manual may require special precautions to
ensure the safety of the personnel performing the operations. Information that
raises potential safety issues is indicated by a warning symbol ( ). Refer to
the safety messages listed at the beginning of each section before performing
an operation preceded by this symbol.
NOTE!
The antenna seal assembly, under no circumstances, should be
disassembled.
To Next Page
Loading...
