RS PRO IIT-2000 - Page 87

IIT-2000/2010/5000/5010 Instruction Manual/English
05/08/2015 Version No. 001 85
0 3 01
A
I R G B A CW D C W
E
F R E Q = 0 H z 6
G B V = V MT I E = 0 0 3 . 2 SR
. 7 m ΩER F =# 0 02
0 0 . 0 m ΩIH ES = 3T
MM A UN N A_2M A N U = * * * - 0 0
m Ω
Reference value
SAP S
Note
Remember to replace the test leads to the proper position on
the DUT before testing.
I<SET
If SOURCE H/L terminals are open or poorly connected, then
the test will fail and an I<SET error will appear on the screen.
Stop the test and re-check the connection again and try again.
Z E R 0 I R G B A CW D CW
E
F R E Q = 0 H z 6
IAF
G B V = 5 . 6 2 2 V MT I E = 0 0 3 . 2 SR
. 0 m ΩER F =# 0 00
0 0 . 0 m ΩIH ES = 3T
MM A UN N A_2M A N U = * * * - 0 0
L
I<SET error message
FAIL status
< I S E T
R = 0
If an R = 0 error message appear on the screen, stop the test
and perform the zero check again.
Z E R 0 I R G B A CW D CW
E
F R E Q = 0 H z 6
IAF
G B V = 5 . 6 2 2 V MT I E = 0 0 3 . 2 SR
. 0 m ΩER F =# 0 00
0 0 . 0 m ΩIH ES = 3T
MM A UN N A_2M A N U = * * * - 0 0
L
R = 0 error message
FAIL status
= R 0