Configuration Guide Configuring PoE Configuration
Fa0/4 enable on 14.7W 8.0W 14.7W 275mA 0 4(Type1) 53.5V
Fa0/5 enable on 28.7W 14.8W 28.7W 538mA 0 4(Type1) 53.5V
Fa0/6 enable on 14.9W 7.8W 14.9W 279mA 0 4(Type1) 53.5V
The following information is displayed if LLDP classification is enabled and the PD is Type 2:
Ruijie(config)#show poe interface fastEthernet 0/2
Interface : Fa0/2
Power enabled : enable
Power status : on
Max power : 30.0 W
Allocate power : N/A
Current power : 14.8 W
Average power : 14.7 W
Peak power : 14.8 W
LLDP requested power : 25.5 W
LLDP allocated power : 25.5 W
Voltage : 53.5 V
Current : 277 mA
PD class : 4(Type2)
Trouble cause : None
Priority : low
Legacy : off
Power-off time-range : N/A
Power management : auto
Ruijie#show poe interfaces status
Interface Power Power Curr Avg Peak Curr Trouble PD Port
Control Status Power Power Power Current Cause Class Voltage
---------------------------------------------------------------------------
Fa0/1 enable on 15.1W 13.1W 15.1W 284mA 0 0 53.5V
Fa0/2 enable on 14.8W 11.9W 14.8W 277mA 0 4(Type2) 53.5V
Fa0/3 enable on 15.2W 13.3W 15.2W 285mA 0 0 53.5V
Fa0/4 enable on 14.7W 8.0W 14.7W 275mA 0 4(Type2) 53.5V
Fa0/5 enable on 28.7W 14.8W 28.7W 538mA 0 4(Type2) 53.5V
Fa0/6 enable on 14.9W 7.8W 14.9W 279mA 0 4(Type2) 53.5V
If the maximum power of a port is set with the max-power command, the LLDP power adjustment function will fail on
this port.
A PoE switch does not allow a PD to send LLDP packets to adjust the priority of the PD itself. The priority of the PD
on a port is uniformly configured and managed by the PoE switch.
Showing the PoE Status of a Port
To show the PoE status of a port, run the following show commands in the privileged mode:
To Next Page
Loading...
