Configuration Guide Configuring PoE Configuration
Fa0/17 enable off N/A N/A low off N/A
Fa0/18 enable off N/A N/A low off N/A
Fa0/19 enable off N/A N/A low off N/A
Fa0/20 enable off N/A N/A low off N/A
Fa0/21 enable off N/A N/A low off N/A
Fa0/22 enable off N/A N/A low off N/A
Fa0/23 enable off N/A N/A low off N/A
Fa0/24 enable off N/A N/A low off N/A
In the outputs of the command for showing configuration information about all PoE ports, the time range in the
Power-off Time-range column shows only the first ten characters if more than ten characters are involved.
Showing the PoE Status of the System
To show the PoE status of the system, run the following show command in the privileged mode:
Ruijie# show poe powersupply
Shows the PoE status of the entire PoE system
For example, you can run the following command to show the PoE status of the entire PoE system:
Ruijie#show poe powersupply
Device member : 1
Power management : auto
PSE total power : 370.0 W
PSE total power consumption : 0.0 W
PSE available power : 0.0 W
PSE total remain power : 370.0 W
PSE peak power : 0.0 W
PSE average power : 0.0 W
PSE powered port : 0
PSE disconnect mode : dc
PSE reserve power : 0%
Device member : 2
Power management : auto
PSE total power : 370.0 W
PSE total power consumption : 277.8 W
PSE available power : 0.0 W
PSE total remain power : 92.2 W
PSE peak power : 306.6 W
PSE average power : 277.8 W
PSE powered port : 12
PSE disconnect mode : dc
PSE reserve power : 0%
The outputs are described as follows:
To Next Page
Loading...
